Free Curbside Delivery
The Equinox Two-Tier Garden Fountain features a simple, elegant design that will enhance any yard or patio. Water bubbles from a copper spout located at the top of the fountain before gently falling into the tiers below. You and your guests will love the soothing sounds created by the cascading water.
Proudly constructed in the USA from premium cast stone concrete.
Each fountain includes a variable speed, U.L. listed, recirculating fountain pump.
The pump plugs into any standard 3-prong 110v electrical.
The pump cord is approximately 5 to 6 feet long and outlet exits out of the back of the fountain base for easy access.
There is no plumbing required for fountain installation. All water recirculates within the fountain by the included fountain pump.
Fountain measures 27.75″ wide x 24.5″ high.
The total weight of this fountain is 240 pounds.
Before winter, all basins and pockets need to be drained, and the pumps removed. The water must be emptied out, rags or burlap placed in the basins to absorb any condensation, and the entire fountain covered with a close-fitting cover. Any fountain left uncovered stands the risk of cracking, chipping, and losing its finish. If the fountain is too big to cover, keep the drains clear or the fountain will fill with water and it will crack. Fountains left outside for winter must be raised above ground level, on wood or blocks.
Pumps should be brought inside during the winter months or ice may crack them. If your pump cannot be removed, make sure the area it is in is dry and then wrap the pump with rags to insulate it.
Be especially careful not to run a pump without adequate water in the fountain or the pump will burn out!! High temperatures or high winds can empty a fountain very rapidly. Keep pump free from debris (i.e., leaves, etc.) especially in spring and fall.
Clean your fountain periodically to keep it looking its best. Turn off the pump and disconnect from electrical source. Scoop out or use a shop-vac to remove any debris and the old water. Then with fresh water, use a soft bristle brush to scrub off algae or dirt. Check that the pump is not clogged with debris. Remove as much soiled water as possible and refill with fresh water and your fountain is ready to go again.
The time between cleanings varies depending on the temperature (algae grows faster in warm weather) and how much debris tends to accumulate in your fountain. Using an algae preventative will extend the time necessary between cleanings. We carry lime remover and organic concrete cleaner for mineral or serious staining problems. We do not recommend the use of bleach or other solvents for cleaning your fountain as they may deteriorate the finish.
|Dimensions||27.75 × 24.5 in|